Top 10 Shark Fin Replacement

genuine oem part

Basically suitable for all models
Style: Shark Fin
Overall size: 17.8cm*6.6cm
Intermediate size: 8cm*6cm/3in*2in
Note: Please check the size before ordering. Not exactly the bottom of the rectangle, so the width of the edges and the middle are different.
Material : High-Quality ABS Material

Compatible With:
Fit for VW: Golf, Beetle, Caddy, Passat, Polo, Jetta
Fit for Mercedes-Benz: A / B / C / E / M / S Class, CLA, GLK, CLS
Fit for Audi: A3, A4, A5, A6, A8
Fit for BMW: 1 / 3 / 4 / 5 / 7 Series, X1, X3, X4, X5, X6
Fit for Mazda: 3, 6, CX-5, CX-7
Fit for Hyundai: ix35, Santa Fe, Tucson, Elantra [It is too short for a 2017 Hyundai Sonata ]!!!
Fit for Honda: Accord, City, Civic, CR-V, Odyssey, [Not fit a 2015 Honda CRV EX Touring. Not large enough to cover all the electronics]!!!
Fit for Chevrolet: Cruze, Malibu, Tahoe, Suburban
Fit for Kia: Rio, Sportage[Doesn’t fit a kia Optima]!!!
Fit for Peugeot: 206, 207, 308, 406, 407
Fit for Ford: Edge, Fusion, Mustang [Didn’t fit fiesta st, It’s to short inside to fit a fiesta st ]!!!
Fit for Suzuki: Swift, SX-4
Fit for Toyota: Camry, 4Runner, Corolla, Highlander, Prius, Sienna, Yaris

PREMIUM TOILET FLAPPER 2″ Shark-Fin Replacement Kit with everything you need to repair a leaking toilet. Leaking is most often caused by a faulty stopper that needs to be replaced. This kit provides an excellent long lasting Siliconized Rubber Flapper along with a sturdy steel chain and hook. Simply follow the directions on the package to install in a few minutes. No experience needed. Gives you a good firm seal that in most cases won’t let your toilet run. That can save big on water bills in many areas where water is expensive. It also helps the environment by responsibly limiting use of drinking water. The flapper resists chlorine and other substances often found in water. The chain and hook are corrosion resistant for a long life of carefree use. PRODUCT FEATURES: Toilet Stopper Flapper 2″ Size Shark-Fin style replacement kit Includes chain and hook Fits many 2-piece toilets including Kohler Stops the most common cause of leaking, running toilet Siliconized Rubber flapper resists chlorine and other chemicals Easy to install with included instructions EASY INSTALL: 1. Turn water supply off, flush toilet to drain tank. 2. Remove worn flapper from lugs on overflow tube. 3. Remove chain from flush lever arm. 4. Attach new flapper to lugs on overflow tube. 5. Fasten chain to flush lever arm with hook. Adjust chain so there is minimum slack when the flapper is in the closed position. 6. Turn on water supply and fill tank. 100% MONEY BACK GUARANTEE ensures this will be your best bet for a pleasing no-risk purchase.

Condition: Brand new
Package includes: One piece of Shark fin antenna.
Material: Made of High quality ABS plastic.
Size(approx.): L 3 3/8″ x W 2 1/8″ x H 2 1/2″ (8.5 x 5.5cm x 6.3cm)
Color: Black

Features:
Original Factory style design.
Easy installation, attached auto grade 3M double-sided adhesive tape fits on any flat surface.
Exclusively trendy design, get your car stand out from crowd!
Dummy decoration antenna/aerial, no reception function.
UV-Protected & Weatherproof coating assures you a more durable product.

Fitment:
Universal fits for Audi A1 A3 A4L A5 A6L A7 A8 Q3 Q5 Q7, also can fit on BMW, MERCEDES, VW, TOYOTA, HONDA, SUV, CROSSOVER.

Note: please make the vent warm before installation if the temperature is under zero Celsius degree & make sure the installed place is completely clean.

Specification
VSWR:1.5:1
Bandwidth:+-5MHz
Impedance:50ohm
Peak Gain >3dBi Based on 7cmx7cm ground plane
Gain Coverage >-4dBi at -90¡ã<0 <+90¡ã(over 75% Volume)

LNA/Filter
LNA Gain (Without cable):28 dBi Typical
Noise Figure(dB)1.5
Filter Out Band Attenuation (f0=1575.42 MHz)
7dB Min f0+/-20MHz;
20dB Min f0+/-50MHz;
30dB Min f0+/-100MHz
VSWR: no more than 2.0
DC Voltage(V):2.7/3.0/3.3/5.0/3.0 to 5.0 etc.
DC Current(mA):11 Max

Mechanical
Weight:131g
Size:84×53.8x62mm
Cable Type:RG174  Length:30cm/11.8″
Connector:Fakra curry female code K
Mounting:Screw(Hole/Roof)
Housing:Black

Environmental
Vibration:Sine sweep 1g(0-p)10~50~10Hz each axis
Humidity:Humidity95%~100%RH
Weatherproof:100% Waterproof

Antenna Replacement Cable
Connector:Fakra curry male code K to SMB female right angle
Cable:RG174 500cm/16.4 Feet

SHARK FIN CHLORINATOR

Specifications:
Height:approx 65mm/2.6inch
Width:approx 70mm/2.8inch
Length:approx 170mm /6.69inch
Material : High-Quality ABS Material

Fitment: Fit for Most of Car, Trucks, etc (Please check the size before you place the order)

Package includes:
1x Shark Fin Antenna

Attributes:

• Functional, Modern, Customized
• Extended length sweeping shark-fin footboards are shaped to maintain a long and lean appearance
• Offers plenty of options for foot repositioning while riding
• Aluminum footboards feature an elegant perforated rubber pad recessed into the surface
• Complements almost any customizing style

Specifics:

• Includes left and right boards
• Color: Same as picture shown (Both chrome and black available)
• Material: Billet Aluminum
• Condition: 100% Brand New Aftermarket Products

Fitment: For Harley Davidson

• ’06-’17 Dyna
• ’00-later Softail (except FXDRS)
• ’86-later Touring models equipped with passenger footboard support. 
• Does not fit Trike Models.

e.g.,
Deluxe FLDE
Fat Boy FLFB
Fat Boy 114 FLFBS
Heritage Classic FLHC
Heritage Classic 114 FLHCS
Sport Glide FLSB
Softail Slim FLSL
Street Bob FXBB
Breakout FXBR
Breakout 114 FXBRS
Fat Bob FXFB
Fat Bob 114 FXFBS
Low Rider FXLR
Road King FLHR
Road King Special FLHRXS
Electra Glide Ultra Classic FLHTCU
Ultra Limited FLHTK
Ultra Limited Low FLHTKL
CVO Limited FLHTKSE
Street Glide FLHX
Street Glide Special FLHXS
CVO Street Glide FLHXSE
Road Glide Ultra FLTRU
Road Glide FLTRX
Road Glide Special FLTRXS
CVO Road Glide FLTRXSE